Testing requirements:
1)CCD detection points should be placed on the surface of the roller as far as possible to avoid measurement errors caused by material jitter and instability of equipment tension.
2)The fixing of CCD and light source must be stable and no jitter.
3)Detection scope: customized according to customer needs.
4)Detection accuracy: ≤ ± 0.1mm.
5)The system is suitable for cathode (positive plate) and anode (negative plate) diaphragm measurements,in which the anode has no AT9 coating area.
System features:
1)Online monitoring of the width of the material being tested.
2)Data analysis and storage for easy data traceability.
3)Sound and light alarm rules are set to facilitate production control.
4)Multi-level rights management and operational guidance to prevent misuse.
5)Supports up to 300 work order information preservation.
6)Start the check function to prevent the system from detecting false positives.
7)Coating defect detection prevents continuous failure of coated defect .
8)Communication input and output management and signal management.
9)Closed loop control upper and lower coating widths coincide<±0.3mm.
10)System abnormal alarm prompt and abnormal solution guide to facilitate system maintenance.